Watering down the paint 50%? It will not cover. I am a contract painter and found that most people that I make a contract with immediately try to change the deal and get more than they are paying for. Sometimes, I let them cheat me as they may have other work that I wish to do but other times I put my foot down. I try to get the client to look at what I have done each and everyday if I am going from room to room. I cannot do this If I spray the entire project at once. Even when I have them inspect my work, they often just do not tell the truth and wish to scam me the contractor for more and more while paying the same as the original contract. Most people have not a clue how much work is involved in painting a house and just assume that the painter rolls out the work with no prep, sealing off the place to protect things that are not painted. All of my contracts state that if anything is in the way like babies, dogs, cars, plants and furniture that I cannot proceed and that it is their responsibility to move this stuff. I always seem to be turned into a furniture mover and never get paid to wrench my back. Fact is most people try to rob the contractor and this article tries to make it seem that the contractor is robbing the homeowners. My sister is a prime example of this as she always goes for the lowest bid yet expects a world class job. This means if you pay $500 for a two day paint job do not expect the contractor to live at your home for two weeks and make only $500.
the price can always be adjusted based on on or off season, amount of colors to be used. A job like this can be done in 2 days and much quicker with a helper. I charge a bit more than others just because its quality work done professionally. Theres others that charge more than this just because they can on the on season and most people dont get a 2nd bid...
Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.
Inspect the surface area for holes, cracks or other problems and apply acrylic caulk to fill them in. Use a putty knife to smooth out the caulk and remove any excess to prevent bumps. For particularly thin or narrow crevices, you may have to use your finger to smooth out the caulk. Caulk contracts and shrinks, so apply a second layer once it's dried.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
I created The Idaho Painter as an alternative to big box DIY video shows that have actors who only act like they can paint but really can barely act. My mission is to teach everyone across the globe how to paint from the non-experienced to the long time professional. No experience is necessary. My channel is for the home improvement person, DIY painter, handyman professional, home and garden enthusiast, and even the professional painter.
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.