To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.

Specify whether the contractor or you will supply the paint. Check Consumer Reports' paint ratings: In its tests, some relatively inexpensive paints performed better than more expensive paints and cost $10 to $20 less per gallon. But keep in mind that most paints will resist cracking, peeling, mold and mildew. Who does the painting — and how well they do it — is more important than what's in the bucket.


A fellow (actually lives in the same neighborhood) by the name of Wayne Hickey (843-655-0366) painted the ceilings and most of the walls of our house in February 2017. He got paint all over my light fixtures, all over my trim around the doors, and had visible lap marks everywhere on the walls. He came back and rectified some of the problems, but not all, as I have noticed as I have had time to look more carefully at the work he and his assistant did. His assistant had no idea (not a clue) how to roll paint on a wall or ceiling. Some places were not covered. He said he would pull nails for pictures and then re-insert the nails exactly where they were. This he did not do as he promised. He painted over the nails. His assistant had no idea how to use a paint roller. I have painted all my life, and would have done this work myself, but I just had a full knee replacement and the other knee is in bad shape. I just could not do the work. Wayne is a pleasant and congenial individual, but he can not cut in a ceiling or wall to my satisfaction - not even close. He should have a putty knife and wet cloth with him all the time to correct any paint that might get applied where it shouldn't. That is something I always did as a painter. I would not recommend Wayne to paint anybody's home.

If you don’t have any lead in your paint, then it’s time to start scraping. Begin with a hand scraper to remove all of the loose paint and tight spots. For larger easy to reach areas, a rotary sander is the tool for the job. You’ll need eye protection and a respirator. The sander is powerful, so you have to be careful not to damage the wood while removing paint. Any paint that is cracked, blistered, or peeling needs to go. Next, smooth the transitions from the bare wood you’ve revealed to the existing paint.
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.

Home Painter Company

×