To get at the nails in the board above, shove a flat pry bar up under it and gently pry the board outward. In most cases, this will pop up the nailhead, so you can pull it with your hammer claw. If you run into a stubborn nail that won’t move easily, don’t use brute force and risk splitting the good board. Instead, slip a hacksaw blade behind the siding and cut the nail (Photo 2).You can’t get the new board in unless you pull the remaining shank of the cut nail (Photo 3).
Hello this is Albert and I will be your go-to guy from here on out for any project you have in mind. I’ve been in the business for over 25 years as my respected father in his trade showed me the way and have been contracting ever since. Born and raised in California We are a family owned and operated company and will get the job done right the first time. We service SoCal. and beyond. No job is too small or big, call today to get your free estimate! Se habla espanol.
Not only careful communication is essential, but we would greatly recommend, when you pick out your type and brand of paint that you go and pay for it, with the contractor's discount, which is given by Sherwin-Williams and most paint companies. Then you will know how much paint you purchased and the coverage. If it is possible, inspect the work of the painter daily.
Hi Richard, Thanks for reaching out. Please visit our website to browse pro reviews in those areas or submit a service request http://www.homeadvisor.com/c.html. If you would like to speak w/ a rep about your project and get assistance finding the right pro in these areas please send your contact info to [email protected] and someone will reach out. -HASupport
Next, undercut the trim to create a gap (Photo 3). When you’re done, scrape any dirt or gunk out of the gap with a putty knife and blow out the dust using a vacuum or air compressor. To avoid staining the concrete, run at least three layers of masking tape under the wood. Apply repellent to all bare wood (Photo 4) including the underside (Photo 5). Bend a putty knife in a vise to make a handy tool for reaching into tight areas. Remove the tape right after application.
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.