The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.
Next, undercut the trim to create a gap (Photo 3). When you’re done, scrape any dirt or gunk out of the gap with a putty knife and blow out the dust using a vacuum or air compressor. To avoid staining the concrete, run at least three layers of masking tape under the wood. Apply repellent to all bare wood (Photo 4) including the underside (Photo 5). Bend a putty knife in a vise to make a handy tool for reaching into tight areas. Remove the tape right after application.
If you decide to hire help, have several contractors inspect the job and provide proposals. You'll probably find huge price differences for the same job. A Checkbook undercover shopper got quotes from nine Washington-area contractors to repaint the walls, ceiling and trim for a living room, dining room, family room, bathroom and kitchen. Including paint and supplies, prices ranged from $2,650 or less to more than $6,500.
Keep an eye on the new cans as they're being brought in. Make sure they look new and don't have paint in the rim of the can. If it's a five-gallon bucket, check to see whether the lid is still sealed on with the plastic strip. The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water.
You’ll easily find the best interior paint colors for your home, from the top brands, here online and at your local Home Depot. Our knowledgeable store associates can help you color-match paint from almost any brand to get the shade of your desire. We’ve also got you covered on all the essential painting supplies, including paint brushes, tarps, drop cloths, plastic sheeting and more.
This is an area that interior painters can easily cut short to save time. Most contracts don't state the extent of the wall repairs included, so it's up to the painter's discretion how much they will do. If it seems like too much work, they'll usually point out the repairs but don't include it in the bid. They'll then ask you if you'd like it fixed after they start your project and let you know how much more it will cost.
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.
Since 1980, House Painting Inc. has aimed for excellence in painting contractor services. Our painters specialize in extensive prep work for the best finished painting results. We respond quickly to customer requests for estimates and job starts. We have earned our reputation as the best painting company in Los Angeles, Pasadena, Santa Monica and the surrounding area.
"Bear Creek Painting did a great job on my house trim. I was having new gutters put on my house but realized that the trim needed to be scraped and painted. Nick was able to get his crew out within a few days. Their work was excellent, timely and Nick was professional and responsive to my need to get the work done quickly. I would definitely use Bear Creek painting for my next painting project."
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
I was a painting contractor for many years and never asked for a deposit upfront. A good contractor should have great credit with his suppliers and an even better contract if the deal should go south before the job is done. Get to know your customer and explain how each paint covers so they understand fully before you have to apply 3 or 4 coats. If you didn't bid your job right and the client has already signed the contract then that is on you not the client. Yes I haven had to eat the difference but the client was happy and a return customer for years so I made up for it.
Climate is another factor to consider. Sunlight, wind, rain and salty weather can all wear out exterior paint. Oil-based paint is durable against wind, rain and temperature changes, but sunlight tends to degrade it. Alkyd paint chalks and sheds very thin layers when it begins to wear. Latex paint is the more durable option for very sun-drenched and relatively dry climate areas. Latex paint with high vinyl content should be avoided, however. Acrylic resin is by far the more durable binder for outdoor latex paint.
When coverage is difficult to estimate, add more rather than less when doing DIY wall painting. You can always pour the leftover back into cans. For large jobs, use the bucket and a roller screen rather than a roller tray. It’s much faster to load your roller with the screen than to use a roller pan. Simply dunk the roller into the paint bucket, then roll it along the screen until it stops dripping.
OF the different type of customers there are at least two: cheap charley's and people who want great results. I agree the need for wall repair is critical to the end results. Most critical is for the customer to be told ahead that the walls are going to need exactly what is needed. This means the contractor must look, touch, examine the walls for defects and needed work. I've been a building manager for 40 years and seen a few paint jobs. Typically a contractor does a lot of talking about how expert he is, but the guys who walk through with note pads, iPads, examine, measure, point things out, explain and recommend are the ones I will deal with. It confirms if they know what the business. Nobody likes the workers to show up and when you talk about the job they're going to do they know nothing but they we were told to be here. Their boss who bid the job doesn't supervise - a big no no around here. Nobody likes surprises or worse, at the end of a job that's not right getting a bunch of little kid excuses. Contractors that do not like the customer to be around looking at the progress don't get the job.
This all comes down to the rules.....1. references....does the contractor have them??? I ALWAYS furnish all my prospective customers them....no excuses...2. insurance....again, I always furnish proof....3. Read the proposal carefully...I ALWAYS list materials down to tape used, the brand, the grit of sandpaper, the manufacturer, etc....its INEXCUSABLE to not list all of these items....I am a member of the PDCA, the Painting and Decorating Contractors of America, the foremost authority in the coatings industry and they also approve of what I listed....if you do not follow these guidelines, you will NOT get a job reflective of "professional". Look for the PDCA where any painting contractors are, if they are not a member, RUN!