The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water. (You never use a sprayer and need to thin paint.?) If i was still in the industry I'd take the time to make a better article than this. Take this for a grain of slat. Use a reputable painter or someone you know you can trust or has been referred to you by someone you trust. I wouldn't hire anyone I had to watch like a hawk to make sure they're not screwing me.
If you're going to do any part of the painting or prep work on your own, you must know that the first step in preparing a surface is washing it. Since dirt can affect the smoothness of a surface area -- and therefore paint's adhesion to it -- use soap to remove any dirt or stains. Make sure there's no soap left on the walls when you're finished; also make sure to remove any gloss with sandpaper and vacuum up the leftover dust.
First off all clients want a "deal" As a painting contractor for 38 years I can tell you that residential-commercial-industrial clients (and their needs are all diffrent. It seems this discussion mostly concerns residential repaints,so here goes--first off ALWAYS get a personal referance from a friend or co-worker. Always get an itemized contract that specifies the prep,color, number of coats, and specifics on payment. Remember you want to set up a relationship with the painting contractor of your choice. Bond, license and insurance are required to get a contractors license and are readily available online at your state Labor and Industries website. Second-- find someone you trust. He or his crew will probably be left alone in your home for most of the time. I always tell my clients that I wont bring someone to their home I wouldnt have in mine. Third--$$ Dont ever pay up front always insist on progress draws if the project is 2 or 3 phases remember If a contractor wants $3000 to do the job and you give him half up front he will be working for $1500. It WILL affect the quality of the product. In 38 years of business I have never taken a deposit and have never not been paid in full remember do what you said you would do for exactly what you said it would cost and there will be no problems with getting paid. one last reminder to clients you are also being evaluated when you interview a contractor. He is sizing you up as well. If he thinks you are a bit sketchy the the price will go up or he wont take the job at all. I have turned down some jobs that looked very profitable on the surface that turned out not to be so.(word gets around fast in the small painting community) Good Luck to clients and contractors
Hi Donnie, Thanks for your comment! We would be happy to help you connect with a fencing pro to give you an estimate on your project. You can submit a request to our pros here: www.homeadvisor.com, browse a list of local pros here: http://www.homeadvisor.com/c.html, or send your info to [email protected] and a project advisor will reach out to assist you. –HASupport
You can save a bundle by doing the labor yourself. The biggest DIY expense is paint. Other expenses include buying or renting supplies and equipment, like caulk, primer, brushes, rollers, tarps and ladders or scaffolding. Freeman advises applying paint with brushes, not a sprayer. “If you overspray all the window frames and overspray your shingles and your sidewalks and the brick on the front of the house, you do damage that is not easily fixed,” he says.
Next, undercut the trim to create a gap (Photo 3). When you’re done, scrape any dirt or gunk out of the gap with a putty knife and blow out the dust using a vacuum or air compressor. To avoid staining the concrete, run at least three layers of masking tape under the wood. Apply repellent to all bare wood (Photo 4) including the underside (Photo 5). Bend a putty knife in a vise to make a handy tool for reaching into tight areas. Remove the tape right after application.
The companies with the best paint products are Benjamin Moore, Dunn Edwards, Sherwin Williams, and Vista Paint. As a painter I don't recommend Berh from Home Depot as much because it's quality is just marketing. Flat paint has no sheen and it shows its true color, but is not easy to wash or clean. Satin, eggshell have low sheen and is washable. Semigloss ang glossy has a high sheen and these paints are recommended for bathrooms and kitchen or where there's high humidity and steam.
Also prime the ends of adjoining boards. This step pays off by slowing the moisture penetration that can lead to peeling at the joints. If the new siding is redwood or cedar, buy a special “stainblocking” primer. Both of these woods contain natural chemicals (tannins) that can bleed through paint, causing brownish stains. A stain-blocking primer will seal in the tannins.
Modern Masters 1 gal. Brass Metallic Interior Paint Modern Masters 1 gal. Brass Metallic Interior Paint can be used to create a high-end decorative finish in a variety of circumstances. Use it on a small accent piece or large architectural specification. Durable and long lasting for commercial application yet easy enough for do-it-yourself projects. Special formula contains real ...  More + Product Details Close
Interior Painting and Restoration: Interior painting for antique buildings often means painting or papering over plaster, which cracks as the building settles and results in moisture stains. Arch Painting remedies these problems by filling and sanding cracks and applying bacteria-resistant primer over discolored areas. Need light carpentry renovations to provide a flawless foundation for your paint? We’re happy to accommodate.
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.

Home Painter Company

×