Every painting job develops a unique choreography as ladders go up and come down and tarps are unrolled and folded up. But two basic principles remain: 1) Start at the top and work down. 2) Work in the shade, out of the sun's glare. As the dance proceeds, keep an eye on the weather. Rain can wash freshly applied latex right off the wall, and a temperature dip below 50 degrees F two days after application can interfere with adhesion and curing and dull the sheen of glossy paints. (Latexes like Sherwin-Williams's Duration and Benjamin Moore's MoorGard Low Lustre are formulated to tolerate temps as low as 35 and 40 degrees, respectively.)
Interesting information! We just got scammed in White Stone, Virginia... we chose the same color, but went from a flat to an eggshell finish. I wasn't available to stand over the painter while he painted. For such a detailed job, I marveled at how quickly he finished the project! After he was paid for the job, we discovered all he did was roll paint across the walls and close to the crown, baseboards and detailed trim around windows and doors leaving about an inch or so of the flat finish. By using the same color, he didn't even do the job he was paid to do, which explained why he could finish the job so quickly. By using the same color... he got lucky and passed it off as a completed job not bothering to paint to and cut in around the trim. Upon further evaluation of our walls we could see exactly where he stopped because we could see the difference between the flat and eggshell finishes. There are walls he didn't even bother to paint. Then where he did paint near the crown when we were in the room watching ... he hit the crown moulding and tried to tell us it was already there... and tried to sell us on painting the crown moulding. I am so disgusted and upset!! He'll be hearing from us to rectify the situation.
Painters often tint primer close to the color of the top coat, but Wallis thinks that's a recipe for "holidays," or missed spots. Instead, he tints his primer a contrasting color. "If I can see the color coming through, I know I need to apply more paint," he says. On the cottage shown in this story, he chose a gray-blue primer to go under a peach top coat.
Hello, My name is Steve I’ve been in trades for more than 20 years. I have an extensive skill set and expertise in many diverse areas, from custom painting to landscaping architecture; just to name a few. Here is a list of some of the many skills I offer. Audio/ Video (TV, Surround Sound, Smart Home, security) Electrical, Plumbing, Drywall Repairs, Furnishing, Flooring, Furnishing, Roofing & More
Back to the article. You can add water to all latex based paints / thinner to oil based paint. The tinting base has absolutely nothing to do with it. Say you are working outside and throughout the day you have to add a little water to keep the same consistency. If somebody really tried to add 20% to 50% water they no longer would be painting they'd be performing a whitewash or pickle finish.
If you're going to do any part of the painting or prep work on your own, you must know that the first step in preparing a surface is washing it. Since dirt can affect the smoothness of a surface area -- and therefore paint's adhesion to it -- use soap to remove any dirt or stains. Make sure there's no soap left on the walls when you're finished; also make sure to remove any gloss with sandpaper and vacuum up the leftover dust.
A fresh paint job has the power to totally transform the look of your house in less time and for less cash than any other remodeling project. That thin skin of resin and pigment also protects your investment, shielding it from sun, wind, and rain—until the paint begins to crack and peel, that is. Then it's time to button up with a couple of new coats. Properly applied, new paint should last for a good 15 years, provided you use top-quality materials, apply them with care (and with an eye on the weather), and, most important, clean and sand every surface first. Here's what you need to know to get a first-class finish on your home's exterior.
Not only do I agree with what you are saying; but, I will not use Angie's List for referrals again. Their "A" rated painter did some of the exact things they are now warning against; however, they are still rated "A". I sent in a review and it took eight weeks to post it. They allowed the contractor to lie about what happened as a response. I had proof and photos. Angie's List is a scam; instead ask neighbors and friends for referrals!
Also prime the ends of adjoining boards. This step pays off by slowing the moisture penetration that can lead to peeling at the joints. If the new siding is redwood or cedar, buy a special “stainblocking” primer. Both of these woods contain natural chemicals (tannins) that can bleed through paint, causing brownish stains. A stain-blocking primer will seal in the tannins.
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.
Prep. For new work the painter accepts the finish done by the drywall or plaster and once he accepts the work and starts painting he owns any wall repairs. Existing work is a different thing. I take a high intensity light and circle the kinds of defects with chalk so we are all in agreement before they start. Sometimes this results in a higher price and we have to compromise on how much to do...
As you scrape, you may find that the wood has turned gray or black in some areas. Check for rot by probing these areas with a nail. Spots that are discolored but firm are simply weathered. Weathered wood doesn’t hold paint very well, so sand away the gray surface. If you find soft areas, you’ve got rot. Small, shallow soft spots can be dug out and repaired with a two-part filler such as Minwax High Performance Wood Filler. But when rot is deep and widespread, it’s best to replace the entire piece of wood.
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.