basic formula? single color exterior labor only ranges from $0.85 to $0.95 per sq foot as a BASE starting point. Prices go up depending on multiple colors, slope of surrounding areas, multiple stories..etc.Some painters charge per window to mask off. Ive seen $25 a window to $50. Interiors without flooring can be factored the same way. When you start having to do multiple colors, cut ins, masking, room isolation...etc. the price jumps considerably. I always start with a base of $0.85 a sq foot and figure it out from there. the season plays a major role too. paint and materials are charged separatly and are typically marked up at a minimum of 15%. I always tell clients this. that way they pick the paint out they want and what quality they want as well. Anyways...thats your base. 1250 sq foot home @ .0.95 a ft = $1,187.50 (one color). Pressure washing, Add another $45-$55 per hour. a 1250 sq ft home is not going to take longer than 2-3 hours if its a single story.
The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water. (You never use a sprayer and need to thin paint.?) If i was still in the industry I'd take the time to make a better article than this. Take this for a grain of slat. Use a reputable painter or someone you know you can trust or has been referred to you by someone you trust. I wouldn't hire anyone I had to watch like a hawk to make sure they're not screwing me.
the price can always be adjusted based on on or off season, amount of colors to be used. A job like this can be done in 2 days and much quicker with a helper. I charge a bit more than others just because its quality work done professionally. Theres others that charge more than this just because they can on the on season and most people dont get a 2nd bid...
For commercial clients, we create bright, professionally finished spaces to bring out the best in your work environment. Our painters show up at the agreed-upon date and time, and we finish the work on time and within budget. We also work closely with contractors on new construction to provide professional prep work, staining and painting for those finishing touches that make it a home. Apartment buildings are another specialty, with reliable service and quick turnaround.
Inspect the surface area for holes, cracks or other problems and apply acrylic caulk to fill them in. Use a putty knife to smooth out the caulk and remove any excess to prevent bumps. For particularly thin or narrow crevices, you may have to use your finger to smooth out the caulk. Caulk contracts and shrinks, so apply a second layer once it's dried.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.