• One room or the whole house? Applying one coat in one room is a reasonable DIY Saturday project (especially if you have help and beer). Multiply the time spent moving furniture, prepping walls and sanding old trim by the number of rooms in the house, and you might want to hire real help. It's the same outside. You can probably tackle one shady garage wall that needs a little scraping and sanding plus a coat of paint, but covering all surfaces of the house is usually best left to a pro.
Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.
to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks  when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
Some contractors work on time and material others on a firm contract. I would never hire the former and am leary of the latter. A contractor may low-ball a bid to get the job planning to make a killing on change orders. If you say good morning to them, they charge you extra for that. If the contract is not very, very specific and extensively fleshed out or if they display their change order schedule prominently on top, show them the door.
I would never suggest that one of my clients buy their own paint because A . They will pay an average of $20 to $30 more per gallon which could add up to $1,000 or more to a full repaint B. most times I'm in the paint store homeowners are kind of pushed to the foreground as they handle all the contractors in the store and C. Paint is heavy, takes up a lot of room needs to be left in it clean dry area and I hate to put a client to work when they are trying to hire me to do their job.

Ask companies to include all details in writing. Although that sounds simple enough, too many contractors submit offers such as "paint house for $5,000." A friendly contractor may offer a reassuring handshake and promise that the crew will take care of all the details — starting on time, working every day, cleaning up, etc. That's great, but why not include each point in the proposal? If it's a challenge to get a written description of labor, materials and other details, things will probably get worse when the work starts.
Good contracts include descriptions of prep work and repairs; paint specs by brand name, type, color and product number; the number of coats; and a full description of the work, including frequently omitted items such as cabinet interiors and shutters. Minimize delays by specifying that, weather permitting, work will be continuous. Get a payment schedule that minimizes the down payment — the more payment you can withhold until the end, the more leverage you'll have to get the job done well and per your specifications. Insist that contractors provide proof that they carry both general liability and workers' compensation coverage.
The companies with the best paint products are Benjamin Moore, Dunn Edwards, Sherwin Williams, and Vista Paint. As a painter I don't recommend Berh from Home Depot as much because it's quality is just marketing. Flat paint has no sheen and it shows its true color, but is not easy to wash or clean. Satin, eggshell have low sheen and is washable. Semigloss ang glossy has a high sheen and these paints are recommended for bathrooms and kitchen or where there's high humidity and steam.
When you refinish your existing cabinet doors, you get a whole new look without the astronomical costs normally associated with a kitchen remodel. It’s a much smarter way to update your space, especially if your cabinets are still in good condition. It doesn’t make sense to throw out perfectly good materials, just because you’re tired of the color.
I made the HUGE mistake of hiring Certa Pro to do several interior rooms of my house, and remove popcorn ceiling in a bathroom. What a nightmare! They didn't paint any door jams, they broke a cedar window sill-and didn't bother telling me, they gouged a hardwood floor, they never sealed the room that had the popcorn removed--causing white powder to be in all rooms of a 2 story home. I can go on and on. Horrible company
Next, undercut the trim to create a gap (Photo 3). When you’re done, scrape any dirt or gunk out of the gap with a putty knife and blow out the dust using a vacuum or air compressor. To avoid staining the concrete, run at least three layers of masking tape under the wood. Apply repellent to all bare wood (Photo 4) including the underside (Photo 5). Bend a putty knife in a vise to make a handy tool for reaching into tight areas. Remove the tape right after application.
Inspect the surface area for holes, cracks or other problems and apply acrylic caulk to fill them in. Use a putty knife to smooth out the caulk and remove any excess to prevent bumps. For particularly thin or narrow crevices, you may have to use your finger to smooth out the caulk. Caulk contracts and shrinks, so apply a second layer once it's dried.
Dave, you said it best! Every pro painting contractor truly worth their salt would and should cut and paste exactly what you say here about where customary and legitimate practices and expectations should be in regards to what customers should expect from contractors and how contractors should professionally deal with their customers. By the way, Dave, if you work in the Atlanta area, I would like to hire you! Thank you for your valuable advice!
I used to work at Sherwin Williams. The best thing to do is specify that you will purchase your own paint. If the painter objects strenuously, he was plaanning on making money in the ways this article outlines. You might pay a few dollars more for paint, but you will have control of the quality of what goes on your walls. Never skimp on paint quality.
In the conventional household painting methods, the customers have always found it a very difficult and cumbersome activity when it comes to getting their homes repainted. The R&D team of MIPPL worked extensively on these products and processes which could enable any house being painted in just a day. This is done at a fixed yet competitive cost that gives our customers a Great Value for their Money. Development of Faster Drying products and sprayable application processes have been the unique introductions of MIPPL that have made such a massive task possible to be completed in such a short span of time.
Are you looking for interior house painters that are local, reliable and the best at what they do? Does the idea of painting the walls of your home fill you with dread? If you want to get the best results with minimal fuss, then make Handy your first choice when you need to connect with expert painting contractors. From preparing your interior walls and ceilings to achieving a neat, professional finish, Handy will put you in touch with the right people for the job. Customize your request by specifying your job details, from how many painters you need to how long you’ll need them. We’ll connect you with the painting professionals that suit you best with no compromise on quality.

Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks  when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.
Lastly, chose a sheen to match the needs of the space. Flat finishes hide imperfections well and absorb light which can make the paint look darker. Eggshells and satins are tough enough to be used in family rooms, kids' rooms, and hallways but don’t hide surface imperfection well. Semi-Gloss and high-gloss finishes are primarily used for trim because they accentuate woodwork details and clean up easily.

Get Best Home Painters Contractor

×